Rain drop sensor with TinkerPie
A board that notices water drops: rain alarms, wet-floor signs.
| Type | Analog sensors |
|---|---|
| Connect to | P10-P13 |
| Gives | 0-100 % (wet = high) |
| Simulator | Yes: a control appears under the simulated board |
How to wire it
Plug the module's A0 / OUT into P10 (or P11-P13 when Wi-Fi is off), VCC to 3.3 V, GND to GND.
Code
In blocks: Accessories category in TinkerPie Studio. As code:
// JavaScript
sensors.rainSensor(Pin.P10)
// Arduino C++
sensors::rainSensor(Pin::P10)